5.2. Passwords and Access Control

This section allows you to change the system passwords and define what IP addresses or networks may access WebTool on this machine.

Figure 5-2. Passwords and Access Control

5.2.1. A Note About Passwords

In the following sections, and in general, it is very important to choose good passwords. Below are a few guidelines on developing good passwords:

One good password method is to take a word and break it up with letters and numbers. For example, to strengthen the password lockbox, change the o's to zero's and throw in some special characters. One result would be l0ck&%b0x.

For more information on developing good passwords please refer to the following article by Ben Thomas on LinuxSecurity.com:

http://www.linuxsecurity.com/content/view/117260/141/

5.2.2. Root Password

root is the administrator account on EnGarde Secure Linux and is the only system user with full-blown privileges to access everything and anything. This field allows you to change the password for this account.

Once you have developed a password you need to enter it a second time for verification.

5.2.3. WebTool Password

This field allows you to change the password used for accessing Guardian Digital WebTool. This password should be different from the root password but just as strong.

Once you have developed a password you need to enter it a second time for verification.

5.2.4. Language

This field allows you to select the default language that WebTool will be presented in.

5.2.5. Trusted Host List

This field allows you to define which hosts and/or networks are permitted to access Guardian Digital WebTool on this machine. You should keep this list as small as possible -- the more people you open up access to, the greater the threat.

You may enter individual IP addresses (ie, 192.168.1.90) or entire networks (ie, 192.168.1.0).